This is chapter forty-six of a series originally titled “Getting Started/Moving Forward with Arduino!” by John Boxall – A tutorial on the Arduino universe. The first chapter is here, the complete series is detailed here.
Welcome back fellow arduidans!
A while back I described how to read multiple buttons using only one analog input pin. However we could only read one button at a time. In this instalment we revisit this topic and examine an improved method of doing so which allows for detecting more than one button being pressed at the same time.
As you know the analogue input pins of the Arduino can read a voltage of between zero and five volts DC and return this measurement as an integer between zero and 1023. Using a small external circuit called a “R-2R ladder”, we can alter the voltage being measured by the analogue pin by diverting the current through one or more resistors by our multiple buttons. Each combination of buttons theoretically will cause a unique voltage to be measured, which we can then interpret in our Arduino sketch and make decisions based on the button(s) pressed.
First the circuit containing four buttons:
Can you see why this is called an R-2R circuit? When building your circuit – use 1% tolerance resistors – and check them with a multimeter to be sure. As always, test and experiment before committing to anything permanent.
Now to determine a method for detecting each button pressed, and also combinations. When each button is closed, the voltage applied to analogue pin zero will be different. And if two buttons are pressed at once, the voltage again will be different. Therefore the value returned by the function analogRead() will vary for each button-press combination. To determine these, I connected a numeric display to my Arduino-compatible board, then simply sent the analogRead() value to the display. You can see some of the results of this in the following video:
The analogRead() results of pressing every combination of button can be found in the following table:
It looks good except for the combinations five and seven – an anomaly which seems odd. Nevertheless your experience may vary as well. But after this experiment we now have the values returned by analogRead() and can use them in a switch… case function or other decision-making functions in our sketches to read button(s) and make decisions based on the user input.
Question - Who came up with the name for the device known as the ‘transistor’?
So now you have a more useful method for receiving input via buttons without wasting many digital input pins. I hope you found this article useful or at least interesting. This series of tutorials has been going for almost two years now, and may soon start to wind down – it’s time to move forward to the next series of tutorials
So if you have any suggestions for further articles (and not thinly-veiled methods of asking me to do your work for you…) – email them to john at tronixstuff dot com.